SpecialtiesHousing
01 Specialty
Enclosures and mounts
A housing or bracket for hardware you already use. Include the board, lens, or rail it must fit.
Illustration
02 The work
What to send us
- The board, lens, connector, or rail it must fit
- Keep-out areas and cable exits
- Whether it is indoors, near heat, or in sunlight
- The mounting surface
Fit and limits
We do not claim a seal, an ingress rating, or a certification. Tell us if the enclosure sees water, sun, or heat.
How we approach it
We fit the housing or bracket to the hardware and the place it is installed, then quote before production.
Typical uses
- Electronics cases
- Sensor mounts
- Camera mounts
- DIN-rail brackets
Materials
- PETG
- ABS / ASA
PETG for an indoor enclosure. ABS or ASA when the part is near heat. We confirm the choice on the quote.
03 Questions
Questions about this work
Is the enclosure waterproof?
We do not claim a waterproof rating. If it will see water, say so and we will tell you whether a printed housing is a fit.
What if the electronics run warm?
Tell us what is near the housing. We will recommend a material for that, or say if the job is outside what we take.
Can you match an existing hole pattern?
Yes. Send the pattern or a model of the mating part.
04 Related